ATTO Technology 2390D Guida di Configurazione Scaricare il pdf (Pagina 202)

NOTE If the command fails, redo your calculations starting from step 1.

5 Verify that the storage can be mounted by typing one of the following

commands:

■ For HP Z800 systems: mount /mnt/StorageMedia

■ For older systems: mount /mnt/stoneMedia

The storage should mount, as the DKU installation script should have

created the mount point directory for your storage (/mnt/StorageMedia

on HP Z800 workstations, or /mnt/stoneMedia on older workstations), as

well as the corresponding entry in the /etc/fstab file.

If you receive an error message and the storage does not mount, follow

the instructions in the next section to manually mount the storage.

Manually Creating a Mount Point and Mounting

the Storage

If the mount point directory for your storage was not created automatically

by the DKU, or if the storage does not mount, perform the following procedure

to create the mount point and mount the storage manually.

To create a mount point and mount the storage:

1 Create the directory that will serve as the mount point for the filesystem,

if it does not exist. For example:

mkdir /mnt/StorageMedia

WARNING Do not use the word “stonefs” as the name for your mount point

directory. “Stonefs” is a reserved word, and can cause issues if used as the

mount point directory name.

2 Mount the XFS filesystem from the logical volume /dev/vg00/lvol1 on the

directory you created in the previous step. For example:

mount -av -t xfs -o rw,noatime,inode64 /dev/vg00/lvol1

/mnt/StorageMedia

The filesystem is mounted as /mnt/StorageMedia.

3 Confirm that the storage is now mounted. Type:

df -h

The output should list /dev/mapper/vg00-lvol1 mounted on your mount

point directory. For example:

192 | Chapter 6 Advanced Configuration and Troubleshooting

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 251 252

Nessun commento

ATTO Technology 2390D Guida di Configurazione Pagina 202